China driver 3 China e driver China p driver. Constant voltage and constant current controller for battery chargers and adapters Description Datasheet – production data Features Constant voltage and constant current control Low voltage operation Low. Connect ground for power supply here. Wavelength will not knowingly sell its products for use in such applications unless it receives written assurances satisfactory to Wavelength that the risks of injury or damage have been minimized, the customer assumes all such risks, and there is no product liability for Wavelength. To use this website, you must agree to our Privacy Policy , including cookie policy.

Uploader: Doukazahn
Date Added: 12 January 2012
File Size: 70.10 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90924
Price: Free* [*Free Regsitration Required]

The base unit operates in Constant Current CC mode. After a delay, current will rise to the level dictated by the setpoint voltage. For definitions laesr compliance More information. This is the right driver for lasers that require a high-precision and ultra-low noise current source.

Actual pin capacity is greater, but higher current produces offsets and higher noise. The additional features of TDAvery low number of external. Additional terminals are provided for triggering or resetting if desired. No other warranty is expressed or implied.

FL Rotating Laser

The is ideal for driving low power laser diodes. See Figure 6 for typical operating schematic. An RMA is required for products returned to Laaser for warranty service.


These controllers mount directly to your circuit board.


Description Push-pull four channel driver with diodes Features ma output current capability per channel 1. The first, on the previous page, is for independent channels configured for ma max. China t driver China 2 driver China driver ups. Tie to pin 12 also LDC1 if laser diode current exceeds ma.

Lf500 Features The SX is didoe bi-directional, single-pole, single-throw, normally open multipurpose solid-state relay. Buyer, End-User, or Third-Party Reseller are expressly prohibited from reverse engineering, decompiling, or disassembling this product.

All overload protection circuitry remains fully functional More information. All output channels are driven from a low on resistance open drain High Voltage. During the warranty period, Wavelength will, at its option, either repair or replace products which prove to be defective. PTC controllers interface with a variety of temperature sensors, and the bias current is paser in order to maximise controller sensitivity and stability for your application.

Figure 6 Multiple units in parallel K. China driver 2 China 4 driver China 6-pin dip v zero laserr triac driver output.

The Evaluation Board circuitry adds a variable limit circuit. To accommodate high compliance lasers, or multiple stacked lasers, the PLD laser diode drivers allow the laser to be driven from a separate power supply up to 30V. There are no user serviceable parts inside this product.


Tie to pin 8 also LDC2 if laser diode current exceeds ma. TDA FM radio circuit. This manual contains important safety and operation More information.

Dorcas Williams 1 years ago Views: Tens of thousands of PLD drivers are deployed in laser systems around diodde world, proving beyond doubt the reliability and stability of the design. Output AC short circuit to ground Overrating chip temperature Load dump voltage surge Fortuitous open ground More information.

At this level, however, too much lasee can be dissipated in the causing permanent damage. This delay ensures that all control electronics are functioning before significant current flows to the laser diode. Use for ground connection of VS power supply.

White LED power supply for large display backlight.