The exact timeout that is set can vary based on the resolution of the timer within the Aardvark adapter. The original application need not be altered or recompiled. The Aardvark adapter is designed so that its internal firmware can be upgraded by the user, thereby allowing the inclusion of any performance enhancements or critical fixes available after the purchase of the device. The nominal timeout that was set is returned back by the API function. Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab. Enable the Aardvark adapter as an I 2 C slave device.

Uploader: Yoramar
Date Added: 4 October 2013
File Size: 17.74 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97365
Price: Free* [*Free Regsitration Required]

Be sure the device driver has been installed before plugging in the Aardvark adapter. After the driver has been installed, plugging in an Aardvark adapter for the first time will cause the adapter to be installed and associated with the correct driver.

Aardvark I2C/SPI Host Adapter – Total Phase

Level Acapter Board Price: Seller information wuweiqi Such a feature is useful if the Aardvark adapter was receiving bytes aarvdark then was forced to wait indefinitely on the bus because of the absence of the terminating stop command.


The Aardvark adapter was unable to seize the bus due to the presence of another I 2 C master. This disclaimer includes, but is not limited to, implied warranties of merchantability, fitness for any particular purpose, and non-infringement.

SCLK is generated by the master device and is used for synchronization.

SPI is a very simple communication protocol. This makes it ideal for data-streaming applications. The Zardvark adapter will then assemble the address into the proper format as described in the Philips specification. First, choose the Rosetta bindings appropriate for the programming language. Similarly, when the Aardvark adapter is configured to act as an SPI slave, and the slave select is pulled high to indicate the end of a transaction, there is a data processing overhead of sending the transaction i2cs/pi the PC host.

Why is this review inappropriate?

Keep in mind that each call to capture pending asynchronous data can have a timeout of up to ms. This is within the USB 1. There is a 2.

There is also a finite time required to set up a byte transmission. Instructions for using this utility can be found below.

Please enter a valid ZIP Code. Therefore, drawing large amounts of current from the host is not advisable.

I 2 C Protocol. A similar problem can happen when one attempts to disable the very slave that is saturating the incoming receive aardvatk


1 General Overview

Upgrading the legacy firmware will cause the Aardvark unit to automatically switch to using the new communications driver interface. Combined I 2 C status code from the write and read operations.

USB Drivers – Windows. This is accomplished on the PC host, courtesy of the operating system. The slave refuses the reception of any more bytes.

Aardvark I2C/SPI Host Adapter

This constraint can be phrased in a different manner. The length value must be greater than 0. Further data may be pending in the operating systems incoming receive buffer, but the function will not examine that data.

The features field denotes the capabilities of the Aardvark device. Learn more about SPI in the article. Repeat steps 3 and 4 until the polling function reports that there is no data available. If the topmost bit of addr is set, the slave will respond to a general call transmission by an I 2 C master.